For extra flexibility and comfort we advise accessories, they are available for every raised access floor.
The Air Vent is made entirely of aluminium and is available standard with four degrees of perforation: 256, 512, 1024 and 1152. The aluminium panel is covered with a top layer in the factory.
This type of Air Vent has been specially designed for rooms and data centres where a high air flow is required. With a through put of 72% this grid has a high air flow with a low pressure drop.
In data centres where a stylish finish is required the VLA is the ideal vent. This aluminium bar grid has a clean finish and contributes positively to the general finish of the data centre.
In data centres and rooms where high(er) air speeds and large pressure differences occur under the floor there is a need to be able to adjust the air flow more accurately.
When a box girder floor is exposed to an extra heavy load, for example by installing a UPS, then a shadow frame can be used. This frame uses the carrying capacity of the substructure.
Some components have an extra high load or create vibrations due to rotating parts (like an air conditioning unit). In order to prevent these vibrations being transmitted to the raised floor an independent frame can be used.
PBS can make almost any cut-outs in a panel in their factory. You just need to give us the specifi cations and our CNC controlled machines will make the correct cut-out.
If a floor or stage is not closed in by walls then the open sides or end can be closed off using bulkheads. These panels close off the floor so that one cannotlook under it.
Inside door step
If the door is not at the same height of the raised fl oor a inside door step can be made. If the floor is higher than 200 mm, then one or more inside door steps are made.
If a height difference must be bridged (for example if a forklift must be pulled onto a raised floor or access for a wheelchair is required) PBS supplies a ramp
When a ramp is required sporadically but there is actually not enough room for a permanent ramp, PBS has a removable available. It is available standard in two sizes.
Three types of cable bushings to feed cables neatly out of a raised floor compartment.
Floor Box Camouflage 45-8P
PBS has developed a floor box specially for low, raised floors: the Camouflage 45-8P. This floor box has an assembled height of approx. 4 cm.
Floor Box Camouflage 55-8P
PBS has developed a floor box specially for low, raised floors: the Camouflage 55-8P. This floor box has an assembled height of approx. 5 cm.
Floor Box Camouflage 70-8P
The Camouflage 70-8P is the lowest floor box in the range fitted with a 4 electrical sockets. The height has been kept as low as possible making it in total not more than 62 mm high.